MVN FLEXISEAL GP

MIXING AND APPLICATION

Preparation

Surface of substrates must be clean, free form grease and oil, loosely adhering particles.

All mortar and concrete surfaces should be brought (SSD - Saturated-Surface-Dry) to a saturated surface dry condition by presoaking with clean water. Remove all excess water just before placing the slurry mortar. 

Mixing

Use a clean container for mixing the MVN FLEXISEAL GP, mixing ratio Component A : B = 1 : 4 (parts by weight)  by slowly adding the powder component (B) to the liquid component (A). For a large batch use the approved mechanical mixer, for a small batch can use the heavy duty slow spead driller with paddle to mixing the mortar.

In typical, when the full quantities of both components are mixed together, a slurry consistency will result suitable for application with brushes and rollers.. For trowel able consisency, use only 4-4.5kg of component A with all of component B (20kg).

Placing

After completed mixing, the homogeneous mortar are ready for application on substrates. Use a brushes, rollers, or spray gun to apply the mortar to the surface requiring waterproofing, ensuring even application to create a continuous film. Apply 2 layers, the direction of the second layer is perpendicular to the direction of the previous layer. The thickness of the waterproofing layer can be from 1-2mm for vertical surfaces and from 1-3mm for horizontal surfaces of the structure to be waterproofed.

Curing

Avoid application in direct sun or strong wind  to prevent the fast evaporation of water. Immediately after completing the waterproofing layer, it is necessary tomaintain the mortar surface to avoid the mortar surface drying too quickly. Use wet burlap or plastic sheet to cover the applied surface. Liquid curing spraying can be used to improving the waterproofing efficiency of applied  material, , avoid the direct influence of rainwater that damages the waterproofing membrane. Maintain maintenance for 3 to 5 days.

Cleaning

All tools and equipment should be rinse with water immediately after use, clean and remove all traces of grout.

HEALTH AND SAFETY

During use, avoid inhalation of dust and contact with the skin and eyes. Wear suitable clothing, gloves, eye protection and respiratory protective equipment.

• Ingredients: Special polymer emulsion 
• Appearance: 

Component A: Liquid, milky white Component B: Powder, Grey

• Packaging: 25kg/set (A+B)

Component A: 5kg/plastic can

Component B: 20kg/paper bag

• Storage: Keep in cool, clean and dry condition 
• Shelf-life: 12 months when properly stored and unopened
• Density: 

Component A: 0.99-1.03 kg/litre

Component B: 1.2-1.4 kg/litre (bulk density)

• Consumption: 1.0-1.2 kg/m²/0.75-1.0mm (depend on condition of substrate). Always requires at least 2 coats.