MVN POLYMER LATEX

SUBSTRATE PREPERATION

• Surface of substrates must be clean, free form grease and oil, loosely adhering particles.
• All mortar and concrete surfaces should be brought to a saturated surface dry condition by presoaking with clean water. Remove all excess water just before placing the slurry mortar.

MIXING AND APPLICATION

• Use a clean bucket to mix the MVN POLYMER LATEX mortar mixture with the appropriate amount of cement to create a mortar mixture with the desired properties. Additional sand (aggregates) can be used in sufficient proportions to create a suitable cement mortar mixture for construction. Depending on the nature of the structure's surface, and other influencing factors, to determine the appropriate construction form and method.

1.  Bonding Bridge

Mixing ratio: Add 4kg of cement into 1litre of  MVN POLYMER LATEX + 1litre of water to result the slurry.

2. Foor screed, Repair mortar: Mix cement and sand first with ratio cement/sand is 1:3 by weight- (Ingredient 1). Dilute the MVN POLYMER LATEX by clean water with ratio Latex/Water is 1:3 by weight- (Ingredient 2). Slowly add ingredient 2 to 1 and mix unstill suitable consistency mixture is achieved

• For all applications, bonding bridge or rendering should be brushed or rolled, in case of floor topping application using the wood float or trowel to finishing the mortar layer. For spray machine can be used to apply the latex mortar onto the substrates
• Not use MVN POLYMER LATEX as bonding agent without adding cement
• Always keep water per cement ratio to a minimum to achieve acceptable consistency, workability.

CURING

• Standard curing practices should be followed.

HEALTH AND SAFETY

• During use, avoid inhalation of dust and contact with the skin and eyes. Wear suitable clothing, gloves, eye protection and respiratory protective equipment.